Locoloc® M2-PDK – Powered Drive Kit

POWERED DRIVE KIT for Type II Swaging Machine to CONVERT Manual Machines to ELECTRIC POWER 

MADE IN THE USA: YES 

Shipping weight: 140 lbs. 

Specifications 

Kit Contains: 

A) 12×19 Mounting Plate
B) Adjustable Base to Tighten Chain
C) Right Angle Gear Reducer including 1-1/2″ HP Single Phase 115 volt
D) Foot Switch with 5 feet of cord connected to motor and 10 feet of cord for connection to power supply.
E) 2 Chain Sprockets and Roller Chain
E) Necessary cap screws to mount gear box, swager and guard.
F) Chain Guard 

Maintenance 

Cleaning:
Dust, dirt, or other foreign material should not be allowed to collect on the swaging machine; it will eventually work its way into the mechanism and cause excessive wear and damage. 

Before installing a set of roll dies, wipe their actives surfaces carefully with a clean, soft cloth to be sure no grit will mar the surfaces of the roll dies. 

Stubborn accumulations of grease or other sticky material can usually be removed by wiping with a petroleum base solvent. 

Lubrication:
Each swaging machine is packed with lubricant when it is assembled at the factory, and no subsequent periodic lubrication is required. If and when the machine is disassembled for repair or overhaul, the old grease on the bearings and gear teeth should be cleaned out with solvent and these parts should be packed lightly with extreme-pressure low-temperature grease, MIL-G-7118 or equivalent. 

Corrosion Protection:
If the swaging machine is in a dusty or humid environment, it is recommended that a hood of fairly heavy vinyl or canvas be used to cover it when it is not in use. 

Contact of bare hands with the working surface of the roll dies must be avoided to prevent fingerprint corrosion. 

Each time a set of roll dies is removed from the swaging machine, the roll dies and the exposed portions of the machine shafts should be lightly coated with a clean corrosion resistant oil.