Locoloc® M2-P Powered

We also offer a power drive for optional application to the Type II Swaging Machine. 

Conforms to MIL Spec MIL-S-6180. 

MADE IN THE USA: YES 

Specifications 

Contains: 

A) M2 Locoloc® Type II Swager.

B) 1.5 Horse Power Single Phase 115 Volt Motor, Type TEFC.

C) Right Angle Gear Reducer.

D) Foot Switch with 7.5 feet of cord connected to motor and 9 feet of cord for connection to power supply.

E) 2 Chain Sprockets, Roller Chain and Adjustable Base to tighten chain.

F) Chain Guard.

G) Steel base plate to which both the reduction gear housing and the swaging machine can be secured in their proper relative locations by cap screws.

Unless otherwise specified in the customer’s purchase order, power drive units will be shipped from the factory wired for 115 volts power supply and the 9 ft. 3-wire power supply cable will have a standard 3-prong plug (2 line and 1 ground) assembled to its free end 

Maintenance 

Cleaning:
Dust, dirt, or other foreign material should not be allowed to collect on the swaging machine; it will eventually work its way into the mechanism and cause excessive wear and damage. 

Before installing a set of roll dies, wipe their actives surfaces carefully with a clean, soft cloth to be sure no grit will mar the surfaces of the roll dies. 

Stubborn accumulations of grease or other sticky material can usually be removed by wiping with a petroleum base solvent. 

Lubrication:
Each swaging machine is packed with lubricant when it is assembled at the factory, and no subsequent periodic lubrication is required. If and when the machine is disassembled for repair or overhaul, the old grease on the bearings and gear teeth should be cleaned out with solvent and these parts should be packed lightly with extreme-pressure low-temperature grease, MIL-G-7118 or equivalent. 

Corrosion Protection:
If the swaging machine is in a dusty or humid environment, it is recommended that a hood of fairly heavy vinyl or canvas be used to cover it when it is not in use. 

Contact of bare hands with the working surface of the roll dies must be avoided to prevent fingerprint corrosion. 

Each time a set of roll dies is removed from the swaging machine, the roll dies and the exposed portions of the machine shafts should be lightly coated with a clean corrosion resistant oil.